Centrex/Pbx Compatibility - Panasonic DBS576 Section 700 Technical Manual

Section 700 - Operation
Hardware Requirements
• Loop-start trunk card (VB-44510)
• Caller ID circuit card (VB-44513)
Related Programming
• FF1-0-01: System (Alpha Tagging)
• FF2-0: Caller ID
• FF2-0: Caller ID Ring Control
• FF3-0: Call Duration Display
Considerations
• The system may be set to display Caller ID in one of two priorities as follows:
Priority Choice 1
• CID name (future feature)
• Alpha tagging if matched
• DID name
Priority Choice 2
• DID name
• CID name (future feature)
• Alpha tagging if matched
• Currently Caller ID only supports the single format (number only). Multiple format (number and
name) is not currently available but is planned as a future feature.
• Caller ID Call Logging only shows the CID number.

Centrex/PBX Compatibility

Description
Centrex/PBX Compatibility allows the System to be connected behind centrex or PBX lines.
The System supports up to 6 access codes for dialing centrex or a PBX. These access codes allow the
System, System Message Detail Recording (SMDR) output to exclude the number dialed to reach a
centrex or PBX line.
When connected behind a PBX or Centrex, Toll Restriction Service (TRS) can be used to restrict
calls.
The System also supports transmission of a flash signal over the centrex or PBX link.
Hardware Requirements
• N/A
Related Programming
• N/A
576-20-700 DBS 576 (USA), issued January 1999
Chapter 3. System Features
29