Paging - NEC DS2000 Release Notes

DS2000 03.20.09/03.21.00 Release Notes
Software Corrections in 03.20.09/03.21.00

Paging

Intercom Speed Dial Key Leaves Extension Connected to Page Zone
Speed Dial, Personal
Pressing Bin Key Quickly After Hang Up Can Cause System Reset
System Programming Cannot Set Up Soft Keys For Bins 706-720
Trunk (Line) Queuing / Trunk Callback
Analog Station Cannot Dial After Callback
34 ◆ 03.20.09/03.21.00
Software version 03.20.09/03.21.00 corrects the following problem that occurred in prior 03.**.**
versions:
1. Keyset user places or answers an outside call.
2. User presses HOLD , then a Speed Dial bin one-touch key (or soft key) programed with Paging
code *10.
3. The keyset goes into the handsfree mode, and remains in the handsfree mode after the user
hangs up the handset.
4. The user must hang up again or press SPK to clear the handsfree mode and go idle.
In prior 03.**.** software versions, if an extension user quickly pressed a Personal Speed Dial bin
(one-touch) key immediately after hanging up an outside call, the system could reset. This is cor-
rected in software version 03.20.09/03.21.00.
In software version 03.20.07, program 1705-Soft Key Configuration could not set up soft keys for
Personal Speed Dial bins 706-720. The program executed correctly, but the soft keys did not work.
This is corrected in software version 03.20.09/03.21.00.
Software version 03.20.09/03.21.00 corrects a problem in prior 03.**.** versions in which a toll
restricted analog station could not dial after a Trunk Callback. The following would occur:
1. Analog station user dials a code for an outside line and hears busy tone.
2. User dials 2 and hangs up.
3. When the trunk becomes free, the analog station rings.
4. The user lifts the handset, hears dial tone on the outside line, and dials their number.
5. The dialed number does not go through.
Another symptom of this same problem is that a toll restricted analog station could not dial any dig-
its after an internal Callback to a co-worker.
This is corrected in software version 03.20.09/03.21.00
DS2000 Release Notes