Relay Playback - Kenwood KXF-W4030 Instruction Manual

This function plays back the tapes in both decks A and B
continuously and repeatedly.
12

Relay playback

1
Load cassette tapes in both decks.
1
Open the cassette holders of decks A and
B.
AUTO REVERSE AUTO REVERSE
A B
TAPE TAPE
- ON – OFF
2 7 3 3 7 2
2
Insert cassette tapes and close the cas-
sette holders of decks A and B.
Deck A:
Playback only.
2
Determine the playback condition.
1
Select the playback mode.
AUTO REVERSE AUTO REVERSE
A B
TAPE TAPE
- ON – OFF
2 7 3 3 7 2
2
Select the Dolby NR mode.
AUTO REVERSE AUTO REVERSE
TAPE A TAPE B
- ON – OFF
2 7 3 3 7 2
3
Start playback.
AUTO REVERSE AUTO REVERSE
A B
TAPE TAPE
- ON – OFF
2 7 3 3 7 2
To Stop relay playback
Press stop (7) key of the deck that is
playing.
AUTO REVERSE AUTO REVERSE
TAPE A TAPE B
- ON – OFF
2 7 3 3 7 2
0
Deck B:
Playback/recording
available.
A B
REV.MODE
DOLBY NR
2 7 3
2 7 3
0
AUTO REVERSE
A
TAPE
- ON – OFF
2 7 3
: Keys and control used in the operations described on this page.
÷ Be sure to remove tape slack before insertion.
÷ Be sure to close the cassette holder securely by pushing it.
Each press switches the indication.
1 "[" : Relay playback of two sides of tapes in decks A and
B is repeated.
2 """ : Relay playback is not available with this setting.
3 """ : Relay playback of only one side of tapes in decks A
and B is repeated.
Each press switches the indication.
1 DOLBY NR "OFF" (extinguished): Dolby NR is not used.
2 DOLBY NR "B": Noise reduction of the ordinary type.
3 DOLBY NR "C": Noise reduction with higher performance.
÷ Select the Dolby NR mode according to the tape recording status.
÷ Tapes are played in the directions indicated by their respective indica-
tors on the display.
÷ The playback starts with the deck the play key of which is pressed.
Listening to cassette tape
0
AUTO REVERSE
B
TAPE
3 7 2