Glossary - Epson Runsense SF-810 User Manual

SF-810 User Manual

Glossary

Term
AT Lap
AT Light
AT Pause
bpm
Calculating calories burnt
Chronograph
Distance
GPS function
Guide distance
Guide time
HR Zone Time
Interval
Lap pace
Lap Pitch
Lap Speed
Lap Stride
Lap time
Pace
Pitch
Pulse Sensor
Appendix
Definition
This automatically records laps when you have run for a fixed amount of
time or a fixed distance.
This automatically turns on the light during lap measuring, alarm
notification, and during the interval function.
Automatically stops measuring when you stop exercising, and resumes
when you continue.
bpm stands for beat per minute. This shows the total pulse (heart rate) per
minute.
Total calories burnt from the start of the exercise.
This function allows you to measure split times and lap times (section
measurement) simultaneously.
Distance from the measurement start point to the current time.
A system that receives signals in a GPS receiver from satellites orbiting the
earth and calculates your current position. This function allows you to
accurately understand positional and time information.
This calculates if you are reaching or falling behind the target pace
distance.
This calculates if you are reaching or falling behind the target pace time.
The time you have remained within the heart rate zone.
A training mode that allows you to perform sets of hard (sprint) and light
(recovery) exercise over a specified time or distance, and repeat the set.
Your pace for the current lap.
Your average pitch per lap.
Your average speed per lap.
Your average stride per lap.
Your time for the lap.
Your current pace acquired from GPS information.
The number of steps taken in one minute while measuring.
This detects your pulse (heart rate) accurately simply by wearing the
device on your wrist.
129