Measuring - Epson Runsense SF-810 User Manual

SF-810 User Manual

Measuring

Operation buttons
A
Display the measurement screen.
Press C on the time screen.
GPS positioning starts, and the measurement
screen is displayed once positioning is complete.
"Specifying a GPS (GPS Positioning)" on
U
page 30
B
Start measuring.
Press C.
C
Record the lap.
Press D while measuring.
The Lap Hold Screen* is displayed for 5 seconds,
and then the measurement screen is displayed.
"Lap Hold Screen" on page 44
U
Measure
* The screen display differs depending on the
settings.
"Screen pattern table" on page 101
U
D
Stop measuring.
Press C while measuring.
Press C to resume measuring.
E
Reset the measurement results.
Hold down D while measuring is stopped.
When you reset the display, it returns to the
status before measuring started allowing you to
start the next measurement.
Data measured up to that point is stored in the
device's memory, and you can check it by
pressing D on the time screen.
"Checking Measurement Data" on
U
page 62
41