Alarm (Tones/Vibration) - Epson Runsense SF-810 User Manual

SF-810 User Manual

Alarm (tones/vibration)

This function allows you to sound an alarm when pausing a lap, setting the target pace, and so on.
The following shows the alarm timing. A long alarm sounds when the lap is paused, and a short alarm sounds at other
times.
Mode
Chronograph AT Lap
❏ From device
Interval
Goal
❏ From PC application (Run Connect)
AT Pause
U
Pause Function)" on page 58
Target Pace
❏ From device
❏ From PC application (Run Connect)
HR
U
Exercise" on page 38
❏ From device
Interval
❏ From PC application (Run Connect)
Goal
U
Advance Is Reached (Goal Function)" on
page 52
Preparing and Basic Operations
Measurement Settings
"Recording Laps Automatically (AT
U
Lap Function)" on page 56
"Setting the AT Lap Function" on
U
page 82
"Automatically Start/Stop Measuring (AT
"Setting a Pace and Measuring (Target
U
Pace Function)" on page 59
"Setting the Target Pace Function" on
U
page 84
"Measuring Pulse (Heart Rate) during
"Setting a Time and Distance for Hard
U
and Light Workouts (Interval Function)"
on page 45
"Setting the Interval Function" on
U
page 87
"Measure until the Time or Distance Set in
When lap is paused
❏ When measuring is stopped
❏ When measuring restarts
❏ When you are off the target pace
❏ When you have set multiple target
paces and the target pace changes
When you are off the HR Zone
❏ When changing between sprint/
recovery
❏ When the number of sets is
complete
❏ When 50/90% of the set time/
distance is reached
❏ When the set time/distance is
complete
22
Timing