Brother DCP-8110DN Service Manual page 200

(6) Disconnect the touch panel harness and LCD flat cable from the panel PCB ASSY.
(7) Remove the screw pan (S/P washer) M3x6 DA screw to remove the touch panel PCB
harness.
(8) Remove the two screw pan (S/P washer) M3x6 DA screws from the panel PCB ASSY.
(9) Release the six hooks, and remove the panel PCB ASSY from the panel cover.
Screw pan (S/P washer) M3x6 DA
Screw pan (S/P washer) M3x6 DA
LCD flat cable
Hooks
(10) Remove the rubber keys L and R from the panel cover.
(11) Remove the panel light guide from the panel cover.
(12) Open the film to remove the seven taptite cup B M3x10 screws, and remove the touch
panel plate from the control panel ASSY.
Taptite cup B M3x10
Touch panel plate
Rubber key R
Panel cover
Assembling Note:
• When securing the touch panel plate with screws, tighten the screws in the
sequence of the numbers engraved on the touch panel plate.
Touch panel PCB harness
Panel cover
Fig. 3-68
Film
Panel light guide
Fig. 3-69
3-54
Panel PCB ASSY
Touch panel harness
Taptite cup B M3x10
5
1 2
Hooks
Hooks
Rubber key L
6 7
3 4
Confidential