Continuous Print Test (Function Code: 67) - Brother DCP-8110DN Service Manual

1.3.19 Continuous print test (function code: 67)

<Function>
This function is used to conduct paper feed and eject tests while printing patterns.
<Operation Procedure>
(1) Press the [6] and [7] buttons in this order in the initial state of maintenance mode.
"SELECT: K 100%" is displayed on the LCD.
(2) Refer to the table below (print pattern), and press the [
pattern you want to print. Then press the [OK] button. "SELECT: A4" is displayed on the
LCD.
(3) Refer to the table below (paper size), and press the [
paper size you want to use. Then press the [OK] button. "SELECT: TRAY1" is displayed
on the LCD.
(4) Refer to the table below (print type), and press the [
with paper set. Then press the [OK] button. "PAPER FEED TEST" is displayed on the
LCD, and printing of the test pattern starts using the selected conditions.
(5) When the [Stop/Exit] button is pressed, printing is stopped, and the machine returns to
the initial state of maintenance mode.
Print pattern
SELECT: K 100%
SELECT: K 1%
SELECT: K 5%
SELECT: Lattice
Paper size
SELECT: A4
SELECT: LETTER
Print type
SELECT: TRAY1
SELECT: TRAY2
SELECT: MP
SELECT: TRAY1 DX
SELECT: TRAY2 DX
SELECT: MP DX
Note:
• Duplex printing only supports 5% intermittent pattern printing. Single-side printing
applies to other patterns even when duplex printing is specified.
LCD
100% solid printing (continuous printing)
1% intermittent pattern printing (500-page printing)
5% intermittent pattern printing (500-page printing)
Lattice printing (continuous printing)
LCD
A4
Letter
LCD
Single-side printing from paper tray 1
Single-side printing from paper tray 2
Single-side printing from MP tray
Duplex printing from paper tray 1
Duplex printing from paper tray 2
Duplex printing from MP tray
] or [
] or [
] or [
Description
Description
Description
5-29
] button to select the
] button to select the
] button to select the tray
Confidential