Yamaha YZF-R1K Service Manual page 152

CAMSHAFTS
7. Check:
• TDC mark a
Make sure that the TDC mark is
aligned with the crankcase mating sur-
face b.
• camshaft punch mark c
Make sure that the camshaft punch
mark is aligned with the arrow mark d
on the camshaft cap.
Out of alignment → Adjust.
Refer to the installation steps above.
8. Measure:
• valve clearance
Out of specification → Adjust.
Refer to "ADJUSTING THE VALVE
CLEARANCE" in chapter 3.
9. Install:
• cylinder head cover gasket
• cylinder head cover
NOTE:
• Apply bond TB1541 onto the mating
surfaces of the cylinder head cover
and cylinder head cover gasket.
• Apply bond 1215B onto the mating
surfaces of the cylinder head cover
gasket and cylinder head.
• Tighten the cylinder head cover bolts
in stages and in a crisscross pattern.
4 - 17
ENG
4