Yamaha YZF-R1K Service Manual page 66

Ô Route the wire harness and turn signal leads
under the rear cowling mounting post on the
tail/brake light bracket.
Insert the tail/brake light coupler and turn sig-
nal leads between the tail/brake light and
tail/brake light bracket.
Ò Position the ground coupler over the oil level
relay lead.
˜ Fasten the starter relay lead, ground lead,
and wire harness with a plastic locking tie.
ˆ Fasten the battery negative lead and wire
CABLE ROUTING
harness with a plastic locking tie.
Ø Route the fuel tank overflow hose and fuel
tank breather hose in front of the crankcase
breather hose and under the fuel hose and
EXUP servomotor.
∏ Fasten the sidestand switch lead, engine oil
level switch lead, generator lead, and wire
harness with a plastic locking tie.
2 - 41
SPEC
2