Yamaha YZF-R1K Service Manual page 67

ΠFasten the wire harness with a plastic clamp
and then insert the clamp into the frame.
 Route the charcoal canister hose under the
EXUP servomotor lead, battery negative
lead, starter motor lead, and EXUP cables
(California only).
Í Insert the plastic clamp into the hole in the
frame.
Ê Route the radiator fan lead over the wire har-
ness.
2
CABLE ROUTING
Ë Fasten the wire harness and radiator fan lead to
the plastic frame panel with a plastic locking tie.
◊ The end of the plastic locking tie must face in.
„ Route the vacuum chamber air vent hoses
through the hole and slit in the rubber baffle.
Ù Route the ignition coil sub-wire harness in front
of the foam damper on the ignition coil plate,
then connect the connectors to the ignition coil
terminals, and make sure that the lead side of
the connectors face up.
2 - 42
SPEC