Yamaha YZF-R1K Service Manual page 59

Ï Fasten the auxiliary light leads with a plastic lock-
ing tie.
Ì Fasten the wire harness to the headlight housing
boss with a plastic locking tie.
Ó Route the headlight lead through the plastic
guide.
È Route the right handlebar switch lead behind the
throttle cables. Do not cross the throttle cables
and the right handlebar switch lead.
Ô Route the thermo switch/temperature sender sub-
wire harness to the outside of the radiator cap.
2
CABLE ROUTING
Route the right handlebar switch lead in
front of the throttle cables.
Ò Make sure that the horn leads face out.
˜ Route the throttle cables and right handle-
bar switch lead between the frame and
plastic frame panel and then between the
lower bracket and lower bracket panel.
Make sure that the right handlebar switch
lead is routed to the outside and the throt-
tle cables are routed to the inside.
2 - 34
SPEC