HP 10:10 LAN Bridge MB Installation And Reference Manual page 30

Note
Novell NetWare uses the IPX protocol. If you are using the bridge on a Novell
NetWare network, no configuration of the bridge is required for it to
communicate with a network management station that is also using the IPX
protocol. IPX is automatically enabled on the bridge. The bridge determines its
IPX address automatically from information received from a router or file server
that is running IPX on the network, and from its own station address (also
sometimes called the MAC address, physical address, or Ethernet address).
See appendix D, "Network Addressing", for more information.
Running IPconfig.
1. From the Config prompt, enter IP to start the IP configuration process. The current IP
configuration values are displayed followed by the IP config prompt.
2. From the IP config prompt, enter CH to change the configuration, then follow the
prompts and instructions on the screen. You will be prompted to enter values for the
parameters listed on the next page.
3. When you have finished your changes, you can enter RE at the prompt to read the new
values you have entered. If any of these values are not correct, enter CH at the prompt
to restart the change process. You need to reenter only the values that are not correct;
press RETURN at the prompt for each correct value.
4. When all the values are correct, enter EX at the prompt to exit from the IP
configuration process. This causes the bridge to reset and to activate the new IP
configuration values.
3-6 Configuration