Chapter 5
General Settings
5.1
PC Terminal Connection
●
ETERNUS DX Environment
Create the operation volume and backup volume in the ETERNUS DX.
Figure 5.2 Example of Creating Operation Volume and Backup Volume
ETERNUS DX
RAID group 0 (RAID1+0)
*1: SDV is used as the copy destination for SnapOPC+ and stores generation data.
*2: SDPVs are volumes that configure the SDP. The SDP is used to assign an area to an SDV when the SDV
capacity is insufficient. When SDPVs are not required, they are automatically released and restored to
their original status.
5.1
PC Terminal Connection
Connect a PC terminal to the ETERNUS DX.
Connect the PC terminal to the RMT port of Controller 0 (CM#0) on the ETERNUS DX directly with the LAN
cable (for operation management).
For the setup information of the PC terminal, refer to
1.6TB × 4
RAID group 1 (RAID5)
1.6TB × 5
FUJITSU Storage ETERNUS DX200F All Flash Array Configuration Guide (Basic)
Copyright 2014 FUJITSU LIMITED
Operation volume
Standard
main
Backup volume
Snap Data Volume (SVD) (*1)
sdv0
sdv1
sdv2
Backup temporary work volume
Snap Data Pool Volume (*2)
sdpv
500GB
"3.3 Preparing the PC Terminal for Setup" (page
36
1TB
sdv3
sdv4
sdv5
sdv6
27).
P3AM-8462-01ENZ0