Powering On; Switching On And Off The Psu Switch On The Power Supply Unit; Figure 5.3 Pc Terminal Connection For Initial Setup; Figure 5.4 On Position (Marked "|") Of The Psu Switch On A Power Supply Unit - Fujitsu ETERNUS DX200F Configuration Manual

Chapter 5 General Settings
5.2

Powering On

The ETERNUS DX and the PC terminal must be connected directly since the network environment of the
ETERNUS DX is set using the PC terminal for the initial setup of the ETERNUS DX.

Figure 5.3 PC Terminal Connection for Initial Setup

PC terminal
5.2 Powering On
This section explains how to turn on the ETERNUS DX.
5.2.1

Switching On and Off the PSU Switch on the Power Supply Unit

Move the PSU switches of the power supply unit in the ETERNUS DX to the ON position (marked "|").
Make sure all of the PSU switches are in the ON position.

Figure 5.4 ON Position (Marked "|") of the PSU Switch on a Power Supply Unit

Power supply unit (PSU#0)
LAN port
LAN cable
RMT port of Controller 0 (CM#0)
Power supply unit (PSU#1)
FUJITSU Storage ETERNUS DX200F All Flash Array Configuration Guide (Basic)
Copyright 2014 FUJITSU LIMITED
37
P3AM-8462-01ENZ0