9.2 Getting Ready
Function
Power Web Management Utility Administrator mode: "Network" tab
FTP
Configuration
*1: Required if notification of the URL is sent by e-mail.
*2: Can also be assigned automatically by the DHCP server.
*3: If there is no SMTP server available over the network, enter "0.0.0.0"
as the IP address.
9.2.2.2 Using the Control Panel To Specify Settings
Network Settings
These settings can be specified from the "NETWORK SETTINGS" menu
in Utility mode.
This section describes how to specify settings for the following functions.
G
IP ADDRESS
G
SUBNET MASK
G
GATEWAY
G
DNS CONFIG.
Note
Be sure to consult your network administrator before specifying any of
the network settings.
Tip
If you wish to cancel a change to a network setting before applying it,
press the [No] key. Press the [Yes] key after the message "STOP
SETTING?" appears.
Internet
Description
Faxing
This function is
-
used to specify the
IP address for the
proxy server of an
FTP server.
Setting
Scan
Scan to
to E-
Control
Server
mail
Panel
●
-
-
9
Power Web
Manageme
nt Utility
2
9-21