Sony XDS-PD1000 Operation Manual page 87

Item number Item name
925
HDMI OUTPUT SELECT
926
DVB-ASI SETTING
Sub-item
1 I/O MODE
2
TS MODE
3 ENC RATE(Mbps)
4
RESOLUTION
5 PROGRAM NUMBER
6 OUTPUT MODE
7 PACKET LENGTH
8 META PACKET OUT
9 PID(PMT)
10 PID(PCR)
Menu items in the 900s, relating to digital process
Settings
Select the resolution of the video output from the HDMI OUTPUT
a)
connector.
1080i, 480i, 480P (59.94i, 29.97P mode)
1080i, 576i, 576P (50i, 25P mode)
720P, 480i, 480P (59.94P mode)
Sets the parameters for DVB-ASI output, and specifies the number of the
a) b)
program to receive when DVB-ASI signals are input.
Sets DVB-ASI input /output.
input [in]: Fixedly input mode
output [out]: Fixedly output mode
c) Selects the TS mode. (59.94i/29.97P/50i/25P mode only).
HDV: HDV mode
Manual [manu]: Encoding rate mode
Sets the encoding rate.
15.00Mbps to 25.00 to 43.25Mbps: Sets the encoding rate.You can set
the rate in units of 0.01 Mbps (or units of 0.20 Mbps, when the
SHIFT button is held down).
- - -: When sub item TS MODE of menu item 926 is set to "HDV".
c) Selects the number of horizontal pixels for the 1080i format. (59.94i/
29.97P/50i/25P mode only).
1440: 1440
When sub-item TS MODE of menu item 926 is set to "HDV", this is
fixed as "1440".
When the encoding rate is set to lower than 35.00 Mbps with sub-
item ENC RATE(Mbps), this is also fixed as "1440".
1920: 1920
Specifies a DVB-ASI input/output signal program number.
1 to 100 to 65535: Sets the program number (decimal).
You can set this in units of 1 (or 20 when the SHIFT button is held
down).
- - -: When sub item TS MODE of menu item 926 is set to "HDV".
Selects the output mode.
Packet [packt]: Packet mode
Burst: Burst mode
Selects the packet length.
188Byte [188B]: 188 bytes
204Byte [204B]: 204 bytes
Specifies output of DVB-ASI TS signal metadata packets.
on: Output metadata packets.
off: Do not output metadata packets
- - -: When sub item TS MODE of menu item 926 is set to "HDV".
Changes the PMT packet PID value for DVB-ASI output.
30 to 81 to 1FFE: Set PID value (as a hexadecimal value).
You can set the value in 1 units (or 20 units, when the SHIFT button
is held down).
- - -: When sub item TS MODE of menu item 926 is set to "HDV".
Note
Do not use the same PID value as for any other sub-item.
Changes the PCR packet PID value for DVB-ASI output.
30 to 134 to 1FFE: Set PID value (as a hexadecimal value).
You can set the value in 1 units (or 20 units, when the SHIFT button
is held down).
- - -: When sub item TS MODE of menu item 926 is set to "HDV".
Note
Do not use the same PID value as for any other sub-item.
87
Setup Menu