Installing An Accessible Drive - Fujitsu CELSIUS W380 Operating Manual

Installing an accessible drive

► Open the casing (see "Opening the casing").
► If a slide-in module is fitted, remove this first. To do this, proceed in the same way as when
removing an accessible drive (see "Removing an accessible drive").
Do not dispose of the empty slide-in module. For cooling, protection against fire, and in
!
order to comply with EMC regulations, you must refit the empty slide-in module if you
remove the drive again later.
► Adjust the required settings on the drive (if necessary, on already-installed drives as well).
1
► Slide the accessible drive into the casing as far as the stop (1).
► Plug the data and the power supply connectors into the drive. Make sure the polarity is correct.
► Press on the retaining clip (2) and, at the same time, slide it up slightly.
► Close the casing (see "Closing the casing").
It may be necessary to modify the entry for the drive in the BIOS Setup.
i
Fujitsu Technology Solutions
2
System upgrades
47