Epson Artisan 700 Service Manual page 122

Epson Artisan 700/Epson Stylus Photo PX700W/TX700W
Take care not to damage the CDR Tray Sensor when removing the
C A U T I O N
CDR Tray Assy. (See
3. Lift the CDR Tray Assy on the side with arms, remove the CDR Tray Assy to
the rear side of the printer.
Rear side
CDR Tray Assy
CDR Tray
Sensor
Right arm
Groove on CDR Guide
Figure 4-95. Remove the CDR Tray Assy (2)
DISASSEMBLY/ASSEMBLY
Fig. 4-94, Fig. 4-95.)
Left arm
Dowel on right arm
Make sure to insert the dowel of the right arm into the groove
on the CDR Guide. (See
Place the left arm over the right arm before installation. (See
Fig.
If an arm comes off, place it to the CDR Tray at an angle as
shown in
on the tray, then rotate it in the direction of the arrow to engage
the arm to the tray.
CDR Tray Assy
When installing the Spur Gear B, engage its teeth with the
grooves on the CDR Tray Assy. (See
After replacing the CDR Tray Assy, make the specified
A D J U S T M E N T
R E Q U I R E D
adjustments. (See
When replacing the CDR Tray Assy, make sure to carry out
the specified lubrication. (See
Disassembly Procedures
Fig. 4-95.)
4-95.)
Fig. 4-96, and insert the hole of the arm into the hook
Hole & hook
Figure 4-96. Reassembling the CDR Tray Assy
Fig.
Chapter 5 "ADJUSTMENT".)
Chapter 6
Revision C
4-94.)
"MAINTENANCE".)
141
Confidential