Fujitsu ETERNUS DX100 S3 Setup Manual page 37

Chapter 3 Initial Setup
3.2 Initial Setup 2
3
Proceed to [Set Date and Time].
3-1
Specify the parameters.
The main setting items are as follows.
-
-
-
-
Click the [Skip] button to proceed to the next screen without setting.
3-2
Click the [Next >>] button.
 A confirmation screen appears.
3-3
Click the [OK] button.
If Yes" is selected for "Synchronize with NTP Server" when there is no NTP server connection or
when communication with the NTP server is unstable, the required time for the date and time
setting may take longer. Wait until the screen is updated. Even if connection to the NTP server
fails, the date and time setting appear as though they have completed. To confirm that the
ETERNUS DX is successfully connected to the NTP server, start this function again and check "Access
Status" in the "NTP Settings" field.
 Setting of the date and time starts.
3-4
Click the [Done] button.
Date/Time Settings
Time Zone Settings
Daylight Saving Time Settings
NTP Settings
FUJITSU Storage ETERNUS DX Configuration Guide (Web GUI)
Copyright 2014 FUJITSU LIMITED
37
P2X0-1250-06ENZ0