Fujitsu XG0224 User Manual page 195

XG Series User's Guide
Default
If up to 128 of "ether macfilter"
subsequent "vlan macfilter"
• Upper limit based on rule
128 rules for the entire device.
For the "ether macfilter",
rules to be used varies depending on the contents of the specified acl as shown below.
The number of rules for each ACL is as follows.
- For ACL to set TCP or UDP
Result of multiplication between the number of source ports and the number of
destination ports for TCP or UDP
- For ACL to set ICMP
Result of multiplication between the number of ICMP TYPEs and the number of
ICMP CODEs for ICMP
- For ACL not to set TCP, UDP, or ICMP
1
You can expand the upper limit to use
resource distribution.
Note 4.
Up to 800 commands can be set for the entire device, including the definitions which refer
to ACL such as "ether macfilter",
"vlan qos aclmap", "vlan ip6qos
ip6 dscp" and "serverinfo filter" commands.
Transmit all packets, assuming that the IP filter is not set.
commands have been defined for port ether1, the
and "lan ip filter" command will be no longer applied.
"vlan macfilter" and "lan ip filter"
"resource filter distribution"
"ether qos aclmap",
aclmap", "lan ip filter",
195
Chapter 5 Command Reference
commands, the number of
command and change
"vlan macfilter", "vlan ip6filter",
"lan ip dscp", "lan ip6 filter",
LAN Information Settings
"lan