Egress Rate Control (Xg2600 Only) - Fujitsu XG0224 User Manual

XG Series User's Guide
• XG0224 / XG0448 / XG0440DC / XG0440DCR
XG0224# configure
XG0224(config)# ether 1-5 mac storm 20000000
discard close
XG0224(config)# commit
XG0224(config)# save
XG0224(config)# exit
4.1.6

Egress Rate Control (XG2600 Only)

It is possible to set an egress rate-limiting value for each port in approximately 40Mbps increments.
To set an egress rate-limiting value, carry out the following procedures in "admin" Operation mode.
XG2600# configure
XG2600(config)# ether 1-5 ratecontrol 8000m
Command
Command
Chapter 4 Switch Functions and their Configuration
Switch to Configuration mode.
Enable storm control, set threshold 20000000 pps, set "discard"
when broadcast traffic exceeds the threshold, set "close" when
multicast traffic exceeds the threshold.
Apply the configuration.
Save the configuration.
Switch to Operation mode.
Switch to Configuration mode.
Specify an egress rate limiting value by 8000M bps for port 1-5.
64
Task
Task
Basic Switch Functions