Configuring Spanning Tree - Fujitsu XG0224 User Manual

XG Series User's Guide
4.5.3

Configuring Spanning Tree

To configure the spanning tree protocol, carry out the following procedure in "admin" Operation mode.
XG2600# configure
XG2600(config)# stp mode stp
XG2600(config)# stp domain 0 priority (0-61440)
XG2600(config)# stp hello (1s-10s)
XG2600(config)# stp age (6s-40s)
XG2600(config)# stp delay (4s-30s)
XG2600(config)# ether 1-8 stp use on
XG2600(config)# ether 9-20 stp use off
XG2600(config)# ether 1-8 stp domain 0 priority (0-240)
XG2600(config)# ether 1-8 stp domain 0 cost
(1-200000000)
XG2600(config)# commit
XG2600(config)# save
XG2600(config)# exit
Command
Chapter 4 Switch Functions and their Configuration
Switch to Configuration mode.
Enable Spanning Tree Protocol.
Configure Spanning Tree Protocol parameters on the device.
• Switch priority
• Hello time
• Maximum aging time (max-age)
• Forward delay time (forward-time)
Enable Spanning Tree Protocol on port 1-8.
Disable Spanning Tree Protocol on port 9-20.
Configure the following parameters related to the spanning tree
topology:
• Port priority
• Path cost
Apply the configuration.
Save the configuration.
Switch to Operation mode.
73
Task
Spanning Tree Protocol (STP)