Serverinfo Sftp Ip6; Serverinfo Telnet - Fujitsu XG0224 User Manual

XG Series User's Guide

5.15.8.14 serverinfo sftp ip6

Function
Available Model
Syntax
Options
Use Mode
Explanation
Caution
Default

5.15.8.15 serverinfo telnet

Function
Available Model
Syntax
Options
Use Mode
Explanation
Default
Set the IPv6 SSH FTP server function
XG0224 / XG0448 / XG0440DC / XG0440DCR / XG2600
serverinfo sftp ip6 <mode>
<mode>
• on
Enable IPv6 SSH FTP server function
• off
Disable IPv6 SSH FTP server function
Configuration mode (admin class)
Set whether or not to enable IPv6 SSH FTP server function
Setting this command OFF and
connection request using the IPv6 address from the sftp client.
Setting this command OFF and the
connection request using the IPv6 address from the sftp client after the password was
entered.
Enabling this command generates an SSH host authentication key at device power-on or
execution of the "reset" command, and it takes several tens of seconds to several
minutes for the processing time. sftp connection is enabled after the SSH host
authentication key generation was completed.
If this device has been started to enable this function while all the ssh and sftp functions
were Off, it also takes several tens of seconds to several minutes for the processing time
to generate an SSH host authentication key. Note that other processes may be affected;
session monitoring timeout may occur, for example.
It is assumed that the IPv6 SSH FTP server function is enabled.
serverinfo sftp ip6 on
Set the TELNET server function.
XG0224 / XG0448 / XG0440DC / XG0440DCR / XG2600
serverinfo telnet ip <mode>
<mode>
• on
Enable the TELNET server function.
• off
Disable the TELNET server function.
Configuration mode (admin class)
Set whether or not to enable the TELNET server function.
It is assumed that the TELNET server function is enabled.
serverinfo telnet ip on
the"serverinfo ssh ip6"
"serverinfo ssh ip6"
313
Chapter 5 Command Reference
command OFF will reject a
command ON will reject a
Device Information Settings