Fault Acknowledge (H6) - Panasonic EBL128 User Manual

Panasonic Eco Solutions Nordic AB
MEW01624 Rev: -
8

FAULT Acknowledge (H6)

Users with access level / type "Information only" can only see the
fault messages, not acknowledge the faults.
LED "General fault" (L7) is indicating that not all faults are
acknowledged and/or corrected.
LED "Fault tx activated" (L11) is indicating that the output for Fault
condition routing equipment (Fault tx) is activated. The LED will be
turned off when all faults are acknowledged.
All faults are normally latched, i.e. all faults have to be acknowledged.
All fault events are stored in the General event log and can be listed. .
In this menu (H6) are up to 200 faults listed:
 Not corrected and not acknowledged faults (no status info.)
 Not corrected but acknowledged faults (status: Acknowledged)
 Corrected but not acknowledged faults (status: Serviced)
If there are no faults, --- List is empty --- will be shown.

Log in with a User name and Password for typ Building officer (or
Service personnel), see page 5.
H1 Perform monthly test
Scroll (or press "6") to menu H6.
H6 FAULT Acknowledge

Press "A". This is a list in which you can scroll. The first fault in the
list is the most recent fault. Status info., see above.

..When applicable, press "" for more info.

To acknowledge the fault shown in the display, press "Fault
acknowledge" (P6). The status will change to Acknowledged if the
fault is not corrected / serviced. If the fault is corrected / serviced it
will disappear from the list. Press "Return" (P9) to leave the list and
go to menu H6.

Scroll to another menu or leave the menu system by pressing
"Return".
7 If faults are set – via EBLWin – to be "Not latched",
be shown.
EBL128 version 2.0.x, Daily user's manual
29
7
Serviced
will never