Table of Contents
Advertisement
110 Power saver (stand by)
The printer unit of your fax machine requires a heat source of approx. 170° C in order to be able to print out
documents immediately. This heat source is heated at specific intervals in order to maintain the temperature at
the required level. This consumes electricity, and the fan also has to run constantly. If you wish to save electric
current or prevent the fan noise, you are able to deactivate the permanent heating facility. The heater in such
cases would only be activated if a fax document is received or printed out. There is a delay of around 20 sec.
before documents can be printed out.
Two alternatives are available:
Super Power Saver:
In this alternative, all components which are not required are switched off (almost the entire electronics) and
the display is therefore also switched off. These measures reduce the entire power consumption of the fax
machine to below 2 VA (Watt). As soon as a copy is inserted, a call is received or a PC print-out performed, the
fax machine resumes its functions.
The Super Power Saver mode is set either with a delay (which can be adjusted between 1 and 60 minutes)
after the last action, or it can be activated by the SUPER POWER SAVER key.
• The Super Power Saver mode cannot be activated when the memory is full (memory display < 100%) and
when a fault lamp is lit.
Printer Power Saver:
The printer Power Save mode only switches off the heating facility for the fixing roller and the fan. All other
functions are retained. The power consumption in this mode is approx. 15 VA (Watt).
You can use a menu for specifying the period during which the printer Power Saver mode is activated.
15-MAR-00 WED 19:56
RESIDUAL MEMORY 100%
1.COMM. OPTIONS
2.LISTS
3.INITIAL SETUP
4.DEFAULT SETTINGS
01.SUPER P. S.
02.PRINTER P. S.
Standby mode
Start the menu
The first 4 menu items are displayed.
Select a menu item
Make your selection
für Powersaver Modus
01: see part A
02: see part B
Continued on next page.
Advertisement
Table of Contents
