Table of Contents
Advertisement
98
Power saver (stand by)
The printer unit of your fax machine requires a heat source of approx. 170° C in order to be able to print out
documents immediately. This heat source is heated at certain intervals in order to maintain the specified
temperature, which requires electricity. If you wish to save on electricity, the permanent heating may be
deactivated. The heater in such cases would only be activated if a fax document is received or printed out.
There is a delay of around 20 sec. before documents can be printed out.
Two alternatives are available:
Super Power Saver:
In this alternative, all components which are not required are switched off (almost the entire electronics) and
the display is therefore also switched off. These measures reduce the entire power consumption of the fax
machine to below 2 VA (Watt). As soon as a copy is inserted, a call is received or a PC print-out performed, the
fax machine resumes its functions.
The Super Power Saver mode is set either with a delay (which can be adjusted between 1 and 60 minutes)
after the last action, or it can be activated by the POWER SAVER key.
• The Super Power Saver mode cannot be activated when the memory is full (memory display < 100%) and
when a fault lamp is lit.
Printer Power Saver:
The Printer Power Save mode only deactivates the heating of the setting roller. All other functions are retained.
The power consumption in this mode is approx. 15 VA (Watt).
You can use a menu for specifying the period during which the printer Power Saver mode is activated.
15-03
19:56
100%
AUTO RECEIVE
MENU
1.FAX FEATURES
POWER SAVER
01.SUPER PS
Standby mode
Start the menu
The first menu item is displayed
Select a menu item
Make your selection
for Power Saver mode
01: SUPER PS
see part A
02: PRINTER PS
see part B
Continued on next page.
Advertisement
Table of Contents
