Table of Contents
Advertisement
Call redial
Auto call redial:
If it was not possible for your fax message to be sent, this may be due to various reasons (please read
page
122). One reason may be that the other fax machine is busy. In this case, it would make sense to call
your partner again at a later time. This is done automatically by your fax; it attempts to send the fax message
again approx. every 3 minutes.
You are able to individually set the period between the call redial attempts and also the number of redial
attempts
(see page
Manual call redial:
If the memory contains a job which you wish to redial immediately, you can select this job and manually select
the redial procedure (see adjacent diagram).
• Manual call redial does not have any influence on the preset number of call redial attempts
REDIAL
PAUSE
START
96).
15-03
19:56
AUTO RECEIVE
REDIAL:
[ENTER]:START
after 5 seconds
FILE NBR =
BLUMBACH
REDIAL
NUMBER NOT LISTED
Manual call redial (from memory)
Standby mode
77%
Requirement:
There must be at least one job which has
already been dialled and not transmitted.
Press the REDIAL/PAUSE key
Make your selection
for selecting the required job
The first available job is displayed.
007
Please refer to
format
Select the job which you want to redial.
confirm with START
The job is carried out again.
If there is no job available for the redial
facility, the machine displays the following
message:
(see page
96).
page 56
for details of the job
53
Advertisement
Table of Contents
