Configuring The Installation - Fujitsu AOYA18LALL Installation And Operating Manual

Heat pump, Split, single service

4 Configuring the installation

F
Optional DHW kit
DHW tank control (with electrical back-up) requires
the use of the DWH kit.
Warning: The tank must be fitted with an electric
back-up, particularly for anti-legionella cycles.
Please refer to section (Operating principle, page 13)
F
Optional 2nd circuit kit
The control of 2 heating circuits requires the
installation of the 2nd circuit.
I f t h e i n s ta l l a t i o n c o n s i s ts o f r a d i a t o r s ( o r
fan-convectors) and a heated floor, zone 2 will
correspond to the radiator (or fan-convectors) zone
and zone 1 to the heated floor zone.
Configuration
(Parameter 5700)
Pre-setting 1
Pre-setting 2
Pre-setting 3
Pre-setting 4
Pre-setting 5
Pre-setting 6
Pre-setting 7
Pre-setting 8
Pre-setting 9
Pre-setting 10
Pre-setting 11
Pre-setting 12
F
Please consult us regarding any other installation configuration.
46
Type of installation
1 heating circuit
1 heating circuit and DHW tank
2 heating circuits
2 heating circuits and DHW tank
Boiler connection and 1 heating circuit
Boiler connection and 2 heating circuits
Boiler connection, 1 heating circuit and DHW tank
Boiler connection, 2 heating circuits and DHW tank
Do not use for heat pump single service. Reserved only for heat pump 2 services
F
Optional boiler connection kit
The connection of an oil or gas boiler to the heat
pump r equires the installation of the boiler
connection kit.
When a boiler is connected to the heat pump, the
heat pump's electric back-ups must not be
connected. It is the boiler that provides the
heating back-up on the coldest days.
The boiler is controlled by the heat pump.
Please refer to the instructions supplied with the
boiler connection kit.
F
Swimming pool kit option
Please refer to the instructions supplied with the
swimming pool kit.
Installation and operating manual "1350-EN"
Page
48
49
50
51
Please refer to the
instructions supplied
with the boiler
connection kit.