Other Operations; Initializing Network Settings; Using Dhcp - Toshiba e-STUDIO 332s User Manual Advanced

Other Operations

This section explains how to initialize the network settings and how to setup your machine and computer
to use DHCP.

Initializing Network Settings

Note
This procedure initializes all the network settings.
Press the <SETTING> key.
1
Press to select [Admin Setup] and
2
then press .
OK
Enter the administrator password.
3
Select [Enter] and then press
4
Press to select [Network Menu] and
5
then press .
OK
Check that [Network Setup] is selected
6
and then press
OK
Press to select [Factory Defaults]
7
and then press
OK
Check that [Execute] is selected and
8
then press .
OK
On the confirmation screen, press
9
to select [Yes] and then press
The network card reboots to initialize the settings.

Using DHCP

You can obtain an IP address from the DHCP
server.
Note
You must be authorized as the administrator.
The network system may go down if you enter an incorrect
IP address.
Memo
You can obtain an IP address from the BOOTP server.
.
OK
.
.
or
.
OK
Configuring DHCP Server
DHCP assigns an IP address to each host on the
TCP/IP network.
Note
The machine must have a static IP address if you want to
print via a network. For details on how to assign a static IP
address, refer to the manual of your DHCP server.
Memo
The following OSes are supported:
- Windows Server 2008 R2, Windows Server 2008, and
Windows Server 2003
The following steps are explained using Windows Server
2008 as an example. The steps and menus may differ
depending on the OS you use.
Click [Start] and select
1
[Administrative Tools]>[Server
Manager].
DHCP
If [ ] is already shown in
Administrative Tools
[
Select [Add Roles] on the [Roles
2
Summary] area.
On the [Add Roles Wizard], click
3
[Next].
Select [DHCP Server] and then click
4
[Next].
Follow the on-screen instructions and
5
configure the settings as necessary.
On the [Confirm Installation
6
Selection] screen, check the settings
and click [Install].
When the installation finishes, click
7
[Close].
Click [Start] and select
8
[Administrative Tools]>[DHCP] to
launch the [DHCP] wizard.
On the DHCP list, select a server to use.
9
From the [Action] menu, select [New
10
Scope].
- 159 -
Other Operations
] continue to step 8.
8