Toshiba e-STUDIO 332s User Manual Advanced page 86

List of the Device Setting Menu Items
Fax H/Modem Rate(For Tx)
Setting
H/Modem Rate(For Rx)
Attenuator
MF Attenuator
Pulse Make Ratio
Pulse Dial Type
MF(Tone) Duration
Calling Timer
PBX Line
Forwarding
Setting
TAD Mode
Tel Priority Mode
CNG Detection
T/F Timer Programming
Soft Ringer Volume
Remote Receive Number
Item
Forwarding Setting
Forwarding Number
Factory
Default
33.6 Kbps Sets the default value of the modem
transmission speed while the machine is
sending a fax.
33.6 Kbps Sets the default value of the modem
transmission speed while the machine is
receiving a fax.
10 dB, Range : Enter Attenuator.It only shows, when Ser-
0-15 dB vice Bit = ON.
8 dB, Range : Enter MF(Tone) Attenuator.It only shows,
0-15 dB when Service Bit = ON.
40 %, Range : Sets the make rate of DP (10 pps) during
33, 39, 40% call.It only shows, when Servic Bit = ON
and Tone/Pulse setting = PULSE.
N, Range : N, Sets the pulse type for dialing. It only
10-N, N+1 shows, when Servic Bit = ON
and Tone/Pulse setting = PULSE.
100 mseconds, Enter MF(Tone) Duration.It only shows,
Range : 75, 85, when Service Bit = ON and Tone/Pulse
100 mseconds setting = TONE.
60 seconds, It only shows, when Service Bit = ON.
Range : 1-
255 seconds
OFF When connecting to PBX (internal
exchange), put it to [ON].
OFF Sets whether to enable or not the fax for-
warding mode.
(NULL) Sets a fax number used for the fax for-
warding mode.
Type 3 Sets an action type at the answering
machine/ fax standby mode.
[Type 3]: A fax signal is detected in 15
seconds from answering by the answering
machine.
[Type 1]: A fax signal is detected right
after the answering machine answers and
reception is performed. By setting to this
type, if there is anything wrong with fax
reception, it may be improved.
[Type 2]: A fax signal is detected right
after the answering machine answers. Set
to this type if you use as a phone mostly.
OFF Sets a timing of phone rings for extension
phone and this machine at the phone/ fax
standby mode.
[ON]: assumes that the party is making a
phone call.
Phone rings are made early.
[OFF] assumes that the part is sending a
fax. If it is judged that the party is not
sending a fax, phone rings are made.
OFF Sets whether to judge that the party is
sending a fax during the off the hook con-
dition at the phone / Fax standby mode.
35 seconds
Sets a time to start the auto reception of fax
when not answering the phone after incom-
ing calls at the phone / fax standby mode or
answering machine / fax standby mode.
Middle Sets a phone ring volume at the phone /
fax standby mode.
OFF Sets a remote switch number.
- 86 -
Description