Configuring Your Machine - Toshiba e-STUDIO 332s User Manual Advanced

Other Operations
On the [New Scope Wizard], follow the
11
on-screen instructions and configure the
settings as necessary.
Memo
Be sure to configure the default gateway settings.
On the [Activate Scope] screen, select [Yes, I want
to activate the scope now].
Click [Finish].
12
Select the new scope from the DHCP list
13
and then select [Reservations].
From the [Action] menu, select [New
14
Reservation].
Configure the settings.
15
Click [Add].
16
Click [Close].
17
From the [File] menu, select [Exit].
18

Configuring Your Machine

The following explains how to configure your
machine to use DHCP/BOOTP.
Note that since the DHCP/BOOTP protocol is
enabled by factory default, you do not have to
perform this procedure.
Memo
The following steps are explained using Network Card
Setup as an example. The steps and menus may differ
depending on the software you use.
Hold down the power switch for about a
1
second to turn on the power.
Turn on your computer and insert the
2
software DVD-ROM.
Click [Run setup.exe].
3
If the [User Account Control] dialog box
appears, click [Yes].
Select a model and then click [Next].
4
Read the license agreement and click
5
[I Agree].
Select [Device Configuration]>
6
[Network Card Setup].
Select your machine from the list.
7
From the [Setting] menu, select
8
[Printer Setting].
Enter the IP address and then click [OK].
9
Enter the password at [Enter
10
Password] and then click [OK].
- The factory default password is the last six digits
of the MAC address.
- The password is case-sensitive.
Click [OK] on the confirmation window.
11
The machine restarts to enable the new settings.
The machine status icon changes to red during the
restart. The status icon changes to green when
the machine has restarted and the new settings
have been enabled.
From the [File] menu, select [Exit] to
12
close the Network Card Setup.
- 160 -