Other Settings; Changing Or Disabling The Operation Start/Finish Sounds; Disabling The 10-Minute Warning Sound - Hitachi BD-S5500 Operating Instructions Manual

Other Settings

Changing or disabling the operation start/finish sounds

A sound is emitted when an operation starts or finishes.
You can select one of 3 settings for the sound.
Press <ON> to turn on the power.
Hold <<WASH DRY>> for at least 3 seconds.
The setting changes as follows each time the button is held for 3 seconds.
Melody
(default setting)
Press <OFF> to turn off the power.
Turning the power off completes the setting.
This setting will be saved.
To change the setting, perform the same operation.

Disabling the 10-minute warning sound

About 10 minutes before an operation finishes, a warning sound is emitted as a notification.
(The remaining time displayed when the sound is emitted may vary during <<WASH DRY>> and <<DRY>>
operations, depending on the selected program and settings.)
You can enable or disable the sound.
To change the default setting (i.e., to disable the sound)
Press <ON> to turn on the power.
Hold <START> for at least 3 seconds.
The setting changes as follows each time the button is held for 3 seconds.
(Ignore the sound that is emitted when the <START> button is pressed.)
Sound enabled (default setting)
Beeps twice and emits the warning
sound to indicate setting.
The sound emitted to indicate change will differ depending on the operation start/finish sound setting.
Press <PAUSE> to pause.
Press <OFF> to turn off the power.
Turning the power off completes the setting.
When a spin cycle is repeated to correct the concentration of the laundry, the warning sound is not emitted.
This setting will be saved.
To change the setting, perform the same operation.
68
To change the default setting
Buzzer No sound
(except the button
operation sound)
Sound disabled
Beeps three times to indicate setting.