Water Supply Inlet; Drain Outlet - Hitachi BD-S5500 Operating Instructions Manual

Table of Contents

Maintenance

Clean the water supply inlet if the water supplying time is unusually long or "C01" appears.

Disconnect the water supply hose.

To prevent water from spilling, perform the following.

Turn off the tap, and press <ON> to turn on the power.

Press <<WASH>> to select the [TUB CLEAN] program.

Press <START> to start.

Run the operation for about 10 seconds, press

<PAUSE>, and then press <OFF> to turn off the power.

Loosen the union nut and remove it.

Remove any debris from the water supply inlet's filter using

a toothbrush or similar tool.

Remove the water supply inlet's filter using pliers before cleaning it.

After removing the water supply inlet's filter and cleaning it, be sure

to reattach it. Failure to do so may result in damage to the water

valve.

Reconnect the water supply hose properly.

(Installation Instructions)

Failure to do so will result in water leakage.

Clean the drain outlet about once per month, or whenever drying operations are unusually long or

"C02" or "C18" appears.

Run a spin operation to make sure the water has drained, and disconnect the drain hose

from the drain outlet.

Place a pan near the drain outlet to catch any remaining water, as the water left inside the drain hose

may spill out.

Remove lint and other debris from inside the drain hose and drain outlet.

Insert the drain hose into the drain outlet, and run a spin operation to check whether

water drains.

Make sure that the end of the drain hose is securely inserted into the drain outlet. (Failure to do so will

result in water leakage.)

Check & ensure that there is no lint or debris around the drain outlet before installing the machine.

Do not remove the lint filter when "C02" appears, as water remains in the drum, and if the lint filter is

Note

removed, a large amount of water may flow out.

(continued)