Hitachi BD-S5500 Operating Instructions Manual page 78

Close the lint filter lid.
Make sure the two tabs are firmly secured.
If the lint filter lid detaches, align the filter lid with the shaft on the
main body of the filter, and push it in vertically.
Orient the lint filter so that the "UP" mark on the filter is
facing up.
Make sure that the rubber seal on the lint filter is still
attached.
Make sure that there is no lint or debris on the lint filter
port and the rubber seal.
Reinsert the lint filter.
Insert the lint filter fully into the port.
Turn the knob clockwise until it clicks into place.
If the knob is not turned until it clicks into place, "C16" will
appear and operation will not be possible.
Insert fully
Close the lint filter cover.
Do not remove the rubber seal.
Removing the rubber seal will result in water leakage.
When reinserting the lint filter, make sure that there is no lint on the rubber seal.
Reinserting it with lint attached may result in water leakage.
If the lint filter or rubber seal is damaged, replace it immediately.
Failure to do so may result in water leakage or malfunction of the machine.
If the lint filter is not securely attached, [LINT FILTER] and "C16" will appear and operation will be disabled to
prevent water leakage. (P. 84)
Lint filter
(continued)
(P. 84)
Turn clockwise until it
clicks into place
(P. 104)
Tabs
If the lint filter lid detaches during cleaning
Filter lid
Shaft on the
main body of
the filter
Filter part
"UP" mark
Rubber seal
Knob
Knob
77