Hitachi BD-S5500 Operating Instructions Manual page 98

Symptom
Did you press the <PAUSE> button during
drying operations?
[TUB COOLING] is
The drum cooling operation is being performed,
displayed.
as the inside of the drum becomes hot during
drying operations.
The remaining time
Operations may extend 1 to 2 hours after the
indicator blinks
[TIME LEFT 10 MIN] indicator appears. This
and does not
occurs automatically when the machine detects
decrease during
that the laundry is not sufficiently dry.
drying operations.
Is the Tangle-Free Finish function set?
This indicator display occurs during the
The remaining
untangle process after spin operations.
time indicator
blinks after spin
operations.
Are you running the [SOFT] program?
This indicator display occurs while warm air is
blowing onto laundry during spin operations.
The remaining In addition to the actual operation time, the
time indicator is remaining time indicator also includes the
longer than the set time used for the correction of uneven laundry
spinning time. distribution, the acceleration of the drum, etc.
The remaining time
If the water pressure was low during the
indicator displayed
previous operation (i.e., the water supply was
immediately after
slow), the displayed time will be extended to
the operation starts
compensate for the longer water supply time.
is longer than that
of the previous
operation. Is the water supply inlet's filter clogged?
Are you running the <STEAM IRON> operation?
[TIME LEFT 1 MIN]
This is because the drum cooling (fan) operation
is displayed for a
is prolonged to cool down the temperature of
longer time.
the inside of the drum.
The liquid crystal
You may have some difficulty seeing the LCD
display (LCD) is
depending on the viewing angle, installation
hard to see (too
environment, and surrounding conditions.
dark/bright)
Is the <DELAY START> function set?
The backlight is off when a delay time is set and
the machine is in standby mode.
The backlight turns on when you press and
The LCD backlight
hold the <DELAY START> button to check the
is not lit.
setting.
Is the backlight auto-off function enabled?
If so, the backlight will turn on and remain lit for
3 minutes whenever you press a button.
Indicators on the
It is a characteristic of the liquid crystal display
LCD become sharp
that image sharpness changes depending on
or dim during
the viewing angle and display content.
operations.
If you wipe the control panel with a dry cloth,
A part of the LCD
a part of the LCD may turn black due to static
turns black.
electricity.
Possible cause Solution
This is not a malfunction.
This is not a malfunction.
The power turns off automatically when you
press the <PAUSE> button, allowing you to
remove the laundry.
For details on the Tangle-Free Finish setting, see
(P. 73).
This is not a malfunction.
This is not a malfunction.
This is not a malfunction.
Clean the water supply inlet. (P. 82)
This is not a malfunction.
This is not a malfunction.
This is not a malfunction.
For details on the <DELAY START> setting, see
(P. 62).
Disable the backlight auto-off function.
This is not a malfunction.
This is not a malfunction.
The phenomenon will soon disappear by itself.
(P. 70)
97