Hitachi BD-S5500 Operating Instructions Manual page 85

Troubleshooting
Indicator and meaning
Drying is not completed,
even after a maximum of 2
to 6 hours of drying.
After a maximum of 10
hours of drying for the
[POWER SAVE] program.
The door cannot be locked or
unlocked.
The lint filter is not inserted
properly.
The lint filter is clogged.
Spinning is not possible.
The drying load is too large.
The drum cannot rotate.
The dry filter is clogged.
If the following occurs, stop operations and contact a service representative.
If the "CXX" indication persists even after performing the above solutions.
If an "FXX" or "CXX" indication not described above persists even after turning the power off and turning it on again.
84
(continued)
Possible cause and solution
Check whether there is lint in dry filter or dry filter port.
If it is clogged, perform maintenance.
Make sure the laundry has been spun and is not tangled.
Press
Make sure water is being properly supplied. (Water is used
<OFF> to
for cooling operations during drying.)
turn off
Refer to the solution for when "C01" is displayed.
the power.
Make sure the drain hose is installed properly.
Refer to the solution for when "C02" is displayed.
Press
Close the door completely.
<PAUSE>
Make sure the laundry load is not too large.
to pause.
Insert the lint filter properly.
Turn the lint filter knob clockwise until it clicks into place.
(P. 76, 77)
Check whether the lint filter is clogged.
Press
If it is clogged, perform maintenance.
<OFF> to
This appears after every 30 times the <<WASH>> and
turn off
<<WASH DRY>> are operated (even if lint buildup is low).
the power.
Make sure the drain hose is installed properly.
Press
Refer to the solution for when "C02" is displayed.
<PAUSE>
Check whether there is excessive foaming.
to pause.
Run a rinse operation before trying to spin again.
Check the size of your laundry load.
Press
Reduce the number of items.
<PAUSE>
The amount of laundry that can be dried depends on the
to pause.
size and type of the items.
Check the size of your laundry load.
Reduce the number of items.
Check whether the laundry is tangled.
Untangle the laundry.
Press
Check whether there is excessive foaming.
<PAUSE>
Run a rinse operation before trying to spin again.
to pause.
Do not use an extension cord to connect the power plug.
Do not connect other appliances to the same power outlet
as the machine.
Check whether there is lint in dry filter or dry filter port.
If it is clogged, perform maintenance.
Press
[DRY FILTER] indicator may light again, even after you
<OFF> to
clean the dry filter and turn the power on. In such cases,
turn off
press the <START> button to turn it off.)
the power.
This appears after every 20 times the <<WASH DRY>> and
<<DRY>> are operated (even if lint buildup is low).
(P. 78, 79)
Press
<ON> to
start the
operation.
Press
<START>
to start
the
operation.
Press
<START>
to start
the
operation.
Press
(P. 76, 77) <ON> to
start the
operation.
Press
<START>
(P. 83)
to start
the
(P. 59)
operation.
Press
<START>
to start
the
operation.
Press
<START>
to start
(P. 59) the
operation.
(P. 78, 79) (The
Press
<ON> to
start the
operation.