Settings That Can Be Changed Via The <Delay Start> Button; Turning Off The Backlight Of The Control Panel - Hitachi BD-S5500 Operating Instructions Manual

Other Settings
Settings that can be changed via the <DELAY START> button
When you hold the <DELAY START> button for at least 3 seconds, three numbers will appear in the display
as shown below.
The displayed numbers indicate the current settings of respective functions.
Example display:

Turning off the backlight of the control panel

When the backlight auto-off function is enabled (set to "On"), the backlight of the liquid crystal
display on the control panel turns off automatically in 3 minutes after operation starts.
If you press any button, the backlight will turn on and remain lit for 3 minutes.
Press <ON> to turn on the power.
Hold <DELAY START> for at least 3 seconds.
Press <WASH>.
Press <START>.
Pressing the <START> button completes the setting.
Press <OFF> to turn off the power.
This setting will be saved.
To change the setting, perform the same operation.
70
(continued)
Turn the backlight auto-off function on or off.
(0: Off)
Adjust the spin speed during the dry cycle of <<WASH DRY>>
operations.
(0: High-Speed Mode)
Adjust the spin startup conditions.
(1: Standard Mode)
The settings in parentheses are the factory default settings.
To change the default setting
The display changes with each press of the
<WASH> button.
Off (default setting)
On
(Automatically turns off
in 3 minutes.)