Add Storage Systems - Hitachi AMS 2100 Getting Started Manual

4. After the software is installed, launch a browser on the management
console and log in to Navigator 2:
http://<IP address>:23015/StorageNavigatorModular/Login
https://<IP address>:23016/StorageNavigatorModular/Login
where <IP address> is the IP address of the management console.
NOTE: If entering an IPv6 address in your Web browser, enter the URL in
brackets. Example: http://[xxxx]:23015/StorageNavigatorModular/Login
5. At the login page, enter system as the default User ID and manager
as the default case-sensitive password.
6. Click the Login button and go to Step
page

13. Add storage systems

The following procedure describes how to add storage systems. As part of
this procedure, you enter the default Account Authentication user ID and
password for the controller (Account Authentication is a security protocol
enabled by default on the AMS). For more information, refer to the Storage
Navigator Modular 2 Storage Features Reference Guide (MK-97DF8148).
1. If the Arrays page is not displayed, click Arrays in the Explorer pane
(see
2. In the Arrays page:
a. Look in the Array Name column for the name of the storage system
you want to configure. Then record the storage system name in
Table 1-10 on page 49
b. Click the name of the storage system you want to configure. The
Account Authentication Log in page prompts you for an Account
Authentication user ID and password (see
22
OR
22.
Figure 1-17 on page
Hitachi AMS 2100/2300 Getting Started Guide
13. Add storage systems on
24).
(you will refer to it later).
Figure 1-16 on page 23).