Hitachi AMS 2100 Getting Started Manual page 32

Figure 1-22: Set Up Host Ports Page (Fibre Channel Ports)
Port Address
Transfer Rate
Topology
2. Click Next to display the following page for configuring the iSCSI ports.
Then enter configuration information for each iSCSI port that will be
used.
30
Table 1-6: Configuring Fibre Channel Ports
Field
Enter the address for the Fibre Channel port.
Select a fixed data transfer rate from the drop-down list that
corresponds to the maximum transfer rate supported by the
device connected to the storage system, such as the server
or switch.
Select the topology in which the port will participate:
• Point-to-Point = port will be used with a Fibre Channel
switch.
• Loop = port is directly connected to the Fibre Channel
port of an HBA installed in a server.
Hitachi AMS 2100/2300 Getting Started Guide
Description