Hitachi AMS 2100 Getting Started Manual page 30

IPv4/IPv6
Use DHCP/Set Manually
Set Manually
If You Selected the IPv4 Protocol in the Set Up Management Ports Page:
IPv4 Address
IPv4 Subnet Mask
IPv4 Default Gateway
Negotiation
28
Figure 1-21: Set Up Management Ports Page
Table 1-5: Configuring Management Ports
Field
Select the IP addressing method you want to use.
For IPv4, Use DHCP configures the management port
automatically, but requires a DHCP server.
For IPv6, Set Automatically configures the management
port automatically.
Lets you complete the remaining fields to configure the
management port manually. If you use IPv6 addresses, note
that these addresses are based on Ethernet addresses. If
you replace the storage system, the IP address is changed.
Therefore, you may want to consider using the manual
setting. As you complete the settings, record them in
Table 1-10 on page 49.
Static Internet Protocol address that client PCs use to access
the base unit's management port.
Subnet mask that client PCs use to access the base unit's
management port.
Default gateway that client PCs use to access the base unit's
management port.
Use the default (Auto) setting to auto-negotiate speed and
duplex mode, or select a fixed speed and duplex setting.
Hitachi AMS 2100/2300 Getting Started Guide
Description