Advertisement
DG-102SH VoIP Station Gateway
5
The DG-102SH VoIP gateway features a Boot Menu, which is described in this chapter.
To access the Boot Menu, you must first make sure the console is connected to the Diagnostics port (an RS-232
port with a 9-socket D-shell connector and DCE-type wiring) and the appropriate cabling for the connection is
being used. Please see the previous chapter, "Configuration," for additional information. Next, power the device
on by simply plugging it in. You will see the POST test and the boot up process. During this process, press
<Ctrl+C> to reach the Boot Menu. If the boot up process has proceeded too far and you did not reach the Boot
Menu shown below, unplug the device, plug it back in (to restart the boot up process), and press <Ctrl+C> until
the Boot Menu appears.
)
This screen allows you to enter information necessary for the initial configuration of this device.
Use the <Tab> key to highlight the first menu item on the Boot Menu, Configure IP, and press <Enter>. The IP
Configuration screen will be displayed:
17
Advertisement
