D-Link DG-102SH User Manual page 27

Voip station gateway

Hide thumbs Also See for DG-102SH:

After making your changes in the fields above, press RESET DEVICE TO START UPDATE to initiate the

update sequence.

"" !+

♦

Software Update Mode This specifies downloading the image file through a WAN Link.

♦

TFTP Server Address The IP address of the TFTP server where the runtime or configuration file is

located. This entry is used only if the Firmware Update is set to Enable.

♦

Firmware Update Determines whether or not the device will try to look for a runtime image file on the

TFTP server.

♦

File Name The complete path and filename of the runtime image file on your TFTP server to be uploaded

to the device.

♦

Last TFTP Server Address This is a read-only field that displays the IP address of the last TFTP server

to be accessed.

Note: After finishing the Update Firmware, please Must perform Factory Reset to make sure firmware

update is complete

To save all the changes made in the current session to the device's flash memory, use the <Tab> keys to highlight

the fourth menu item on the Boot Menu, Save Changes, and press <Enter>. The Saving Settings screen will be

displayed:

DG-102SH VoIP Station Gateway