Advertisement
♦
Mode Choose the Gatekeeper mode.(Default is Auto)
♦
Gatekeeper IP Address This IP address is necessary if you chose the Manual mode defined as above.
♦
Gatekeeper Identifier This is used to set the gatekeeper identifier information that is carried in the
H.323 RAS messages.
♦
Send Keepalive RRQ to Gatekeeper Enables or disables the Keepalive function.
♦
Keepalive Interval This is a user-defined Keepalive Interval
♦
GK Max Fails This is used to control how many RAS message attempts will be made before the endpoint
considers itself to fail.
♦
GK Rsp Timeout This is used to set the RAS packet response time. When RAS request send out to
gatekeeper, it expect to get the RAS response from gatekeeper. If the response time longer than
gk_rsp_timeout, the endpoint will re-send this RAS request. If more than gk_max_tries times, gatekeeper
is considered as lost connection.
H.323 Information
♦
Display Name This is used to set the display name information that is carried in the H.323 setup
messages.
♦
H.323 ID This is used to set the H323 ID information that is carried in the H.323 Q.931 SETUP messages.
♦
Terminal Type (0...255) This is used to set the H.245 terminal type. The terminal type is used as part of
the master/slave determination process of H.245. The "master" side of the call is responsible for resolving
conflicts when conflicting conditions occur.
♦
End Point Register Type This is used to set the endpoint registration type. This should not be confused
with the H.245 terminal type, although the two parameters should be programmed consistently. This
parameter specifies how the endpoint will register itself with the gatekeeper, and has nothing to do with
master/slave determination.
♦
Rtp Port Base This is used to select the starting port number for assignment of RTP and RTCP ports.
When H.323 calls are made an RTP and RTCP port is opened for each call. The H.323 specification states
that the RTP port number should be even in value and the RTCP port number should be one greater than
the RTP port value.
♦
Rtp Tos This is used to set type of service value in IP header for RTP packets
♦
Ras Tos This is used to set type of service value in IP header for RAS packets
♦
H225 H245 Tos This is used to set type of service value in IP header for H.225 and H.245 packets
♦
Fast Start Enables or disables the Fast Start mode
♦
Auto Answer Enables or disables early call setup connection. If disabled, the call is not set up until the
user initiates the connection.
Click on the Save button at the bottom right of the screen to save the settings.
Send Register/Unregister to Gatekeeper Determines whether or not the device register to Gatekeeper.
27
DG-102SH VoIP Station Gateway
Advertisement
