Advertisement
The DG-102SH VoIP gateway offers a line-at-a-time prompt and response scheme to execute various
configuration instructions. The interface displays a single prompt character ggdbg> when it is ready to accept a
command (ex. ggdbg>set or ggdbg>show).
Typing a question mark after the ggdbg> prompt will display a list of helpful user commands. Please note that all
characters must be entered in lower case. For the sake of explanation, all command line examples in this chapter
are in bold type.
See below for a list of some of the most commonly used commands, parameter(s), and examples of their usage.
!
nwdbg system reboot
Definition:
Parameter(s):
Example:
nwdbg save changes
Definition:
Parameter(s):
Example:
nwdbg factory reset
Definition:
Parameter(s):
Example:
nwdbg un <USERNAME>
Definition:
Parameter(s):
Example:
nwdbg pw <PASSWORD>
Definition:
Parameter(s):
Example:
nwdbg slic <0|1>
Definition:
Parameter(s):
Example:
This command is used to restart the device.
None.
nwdbg system reboot
This command is used to save configuration changes into flash and then restart the device.
None.
nwdbg save changes
This command is used to change all of the configuration data to the default values, save the
new configuration data into flash, and then restart the device.
None.
nwdbg factory reset
This command sets the username if there is a username string, or shows the
username/password if only nwdbg un is typed.
<USERNAME, maximum string length is 12 characters>
nwdbg un 123456789012
This command sets the password if there is a password string, or shows the
username/password if only nwdbg pw is typed.
<PASSWORD, maximum string length is 12 characters>
nwdbg pw
This command changes the Subscriber Line Interface Circuit (SLIC) state to standby or
active, or shows the SLIC state if only nwdbg slic is typed.
<slic state, 0 : standby, 1 : active >
nwdbg slic 0
65
DG-102SH VoIP Station Gateway
7
Advertisement
