Panasonic KX-TDA100 Programming Manual page 105
Hybrid ip-pbx
Hide thumbs
Also See for KX-TDA100:
- Programming manual (912 pages) ,
- Pc programming manual (854 pages) ,
- Features manual (776 pages)
Table of Contents
Advertisement
A
•
From the 2.7.11 [1-1] Slot—LCO Port screen, modify the CPC Signal Detection
Time—Outgoing, Incoming setting of the target port.
The required value varies by carrier. Transmission and reception can be set separately.
Q
What settings do I change to enable use of an extension ISDN telephone?
A
•
From the 2.7.14 [1-1] Slot—BRI Port screen, set the Port Type of the port you want to
use to "Extension".
Q
When using a TE with an extension ISDN, how do I enable power output?
A
•
From the 2.7.14 [1-1] Slot—BRI Port screen, set ISDN TE Power on the ISDN
Extension tab to "Enable".
Q
How do I connect to another PBX using QSIG?
A
•
From the 2.7.14 [1-1] Slot—BRI Port or 2.7.16 [1-1] Slot—PRI Port (KX-TDA100/KX-
TDA200/KX-TDA600 only) screen, set the Port Type of the port you want to use to
either "QSIG-Slave" or "QSIG-Master".
Q
How do I change the type of an extension port?
A
•
Set the port to OUS status. Then, change DPT Type—Type (for DPT or S-Hybrid port)
in the 2.7.5 [1-1] Slot—Extension Port window.
Q
I have set the type of an extension port to "DSS Console", but I cannot apply
this setting. (Error E000402)
A
•
The number entered in DPT Type—Location No. (for DPT or S-Hybrid port) on the
2.7.5 [1-1] Slot—Extension Port screen is the same as that entered for another DSS
Console. Change this so that the numbers do not overlap.
Q
I have set the type of an extension port to "VM (DPT)", but I cannot apply this
setting. (Error E000403)
A
•
The DPT Type—VM Unit No. (for DPT or S-Hybrid port) and DPT Type—VM Port No.
(for DPT or S-Hybrid port) settings entered on the 2.7.5 [1-1] Slot—Extension Port
screen are the same as those entered for another VM (DPT). Change this so that the
numbers do not overlap.
Q
I have set the type of an extension port to "PC Console", but I cannot apply this
setting. (Error E000402)
A
•
The number entered in DPT Type—Location No. (for DPT or S-Hybrid port) on the
2.7.5 [1-1] Slot—Extension Port screen is the same as that entered for another PC
Console. Change this so that the numbers do not overlap.
Q
What programming do I have to perform to use a headset with an extension?
A
•
Set Headset OFF/ON (for DPT, DPT(S-DPT), S-Hybrid, or S-Hybrid(S-DPT) port) on
the 2.7.5 [1-1] Slot—Extension Port screen to "Headset ON".
Q
What programming do I have to perform to use XDP with an extension port?
A
•
Set XDP Mode (for S-Hybrid port) on the 2.7.5 [1-1] Slot—Extension Port screen to
"On".
2.6 Help
PC Programming Manual
105
Advertisement
Table of Contents
