Panasonic KX-TDA100 Programming Manual page 128

2.7 [1] Configuration
Feature Guide References
1.11.9 Parallelled Telephone
DPT Type—Type (for DPT or S-Hybrid port)
Selects the port type.
To change the port type of an extension port, follow the steps below:
1.
Set the status of the extension port to "OUS".
2.
Change the port type of the extension port, then click Apply.
3.
Set the status of the extension port to "INS".
When changing the port type of an extension port for which Wireless XDP has been set on the
2.10.1 [4-1-1] Wired Extension—Extension Settings screen, the Wireless XDP setting must
be deleted first.
With MPR Software File Version 3.1000 or later, when changing the type of a port for which one
or more SDN buttons are set (except when changing between PC Console and Telephone), all
SDN buttons customised for that device will be deleted. When you attempt to apply the new
settings, a warning message is displayed showing the slot and port number for which SDN
buttons will be deleted. If you do not wish to delete SDN buttons for this port, click Cancel.
Value Range
Normal: For connecting a DPT
DSS: For connecting a DSS Console (A maximum of 4 [with the KX-TDA30], 8 [with the KX-TDA100/
KX-TDA200] or 64 [with the KX-TDA600] DSS Consoles can be connected to the PBX.)
VM (DPT): For connecting a Panasonic VPS through DPT Integration
PC Console: For connecting a PC Console (A maximum of 2 [with the KX-TDA30] or 8 [with the KX-
TDA100/KX-TDA200/KX-TDA600] PC Consoles can be connected to the PBX.)
Maintenance Console Location
2.7.5 [1-1] Slot—Extension Port
Programming Manual References
2.7.6 [1-1] Slot—Extension Port—Port Command
Feature Guide References
1.24.1 Voice Mail (VM) Group
1.32.1 Computer Telephony Integration (CTI)
DPT Type—Location No. (for DPT or S-Hybrid port)
Specifies the location number of the connected DSS Console or PC Console.
Note that, depending on system traffic, there may be a limit to the number of PC Consoles that can
be supported by a single DLC/DHLC card.
With MPR Software File Version 3.1000 or later, when changing the location number of a DSS
Console for which one or more SDN buttons are set, all SDN buttons customised for that device will
be deleted. When you attempt to apply the new settings, a warning message is displayed showing
the slot and port number for which SDN buttons will be deleted. If you do not wish to delete SDN
buttons for this port, click Cancel.
128 PC Programming Manual