Panasonic KX-TDA100 Programming Manual page 519

Programming Manual References
None
Feature Guide References
None
Timing—Waiting Time before Sending VM DTMF Status Signal
Specifies the length of time that the PBX waits before sending the DTMF status signal to the VPS
after the VPS has finished dialling.
Value Range
0.5 s, 1.0 s, 1.5 s, 2.0 s
Maintenance Console Location
2.9.19 [3-8-1] VM(DTMF) Group—System Settings
Programming Manual References
None
Feature Guide References
None
Others—Call Waiting on VM Group
Enables the queuing of calls when all extension ports of the VM (DTMF) group are busy. (Call Waiting
tone is not sent to any VM port.)
Value Range
Disable, Enable
Maintenance Console Location
2.9.19 [3-8-1] VM(DTMF) Group—System Settings
Programming Manual References
None
Feature Guide References
1.2.2.4 Queuing Feature
Others—FWD to the VPS Sequence
Specifies which DTMF commands the VPS receives from the PBX when a call is forwarded to the
VPS, so that the VPS can answer the call either with a mailbox or in the AA service mode. It is also
possible to send no DTMF signal to the VPS.
Value Range
None, Answer by Mailbox, AA
2.9 [3] Group
PC Programming Manual 519