Toshiba MMW-AP0271LQ-E Service Manual page 32

Monitoring function of wired remote controller
The following monitoring function is available if the remote controller of RBC-ATM32E is used.
Content
Enter the service monitoring mode using the remote controller to check the sensor temperature or
operation status of the remote controller, indoor unit, and outdoor unit.
1
Push and hold the
The service monitor lights up. The temperature of CODE No.
2
Push the
table for CODE No.
3
Push the
UNIT LOUVER
sensor temperature or operation status of the indoor unit and outdoor unit in the
refrigerant line
4
Push the to return the display to normal.
NOTE:
The LED on the P.C. board of the selected hot water module flashes. The hot water module for change
settings can be confirmed.
, and for 4 seconds or longer to enter the service monitoring mode.
button to change to CODE No. of the item to monitor. Refer to the following
button (left side of the button) to change to the item to monitor. Monitor the
– 32 –
00 00 00 00 00
appears at first.