Toshiba MMW-AP0271LQ-E Service Manual page 73

No. Part to be replaced
Base and legs
10
2way valve coil
11
PMV motor
12
Work procedure
1. Detachment
1) Carry out the detachment of item
2) Remove the screws for the legs.(5x10, 8pcs.)
Base Base Base
2. Attachment
1) Carry out installation by following the detachment
procedure in reverse.
1. Detachment
1) Carry out the detachment of item
2) Remove connector which is connected from the control
P.C.board to the other part and then remove wiring from
the clamp.
CN033 ... (LM) 2way valve
3) Remove the screw for the 2way valve coil.(M5x6.5, 1pc.)
2. Attachment
1) Carry out installation by following the detachment
procedure in reverse.
NOTE:
• Control the tightening torque for the 2way valve coil to
2.0 ± 0.5N•m.
• Be careful in the insertion direction of attaching the
2way valve coil, as shown below.
• Let 2 way valve coil wiring pass through the letf side
clamps.
Refer to item (Electrical control box).
4
1. Detachment
1) Carry out the detachment of item
2) Remove connector which is connected from the control
P.C.board to the other part and then remove wiring from
the clamp.
CN082 ... PMV Blue
3) Loosen the nuts fixing PMV motor with double spanner
to remove PMV motor.
2. Attachment
1) Carry out installation by following the detachment
procedure in reverse.
NOTE
• Control the tightening torque for the PMV motor to 7.84
± 0.98N•m.
• Let PMV wiring pass through the letf side clamps.
Refer to item (Electrical control box).
4
(Drain pan).
9
Leg Leg Leg
(Front panel).
1
Green 3P
(Front panel).
1
6P
– 73 –
Remarks
Spanner Spanner
2way valve coil 2way valve coil
2way valve coil
drection
PMV motor PMV motor PMV motor
Spanner Spanner Spanner
PMV body PMV body PMV body